I’ve been a fan of the game of Labyrinth for a while. I spent hours as a kid mastering the X-Y controls to move the steel sphere from Start to Finish to Start to Finish, back and forth continuously. It was almost an obsession.
I started helping at a youth group and found that they have no games. What could be better than a giant Labyrinth game! And why not use SolidWorks to design this latest innovation in gigantic fun! If only I had a workshop. Building this in a one bedroom apartment has its disadvantages. Click “More” for details of the project and the virtual solution with SolidWorks Motion.
To get started on this project, I grabbed a layout picture of the original game. Inserting this into a sketch (Tools > Sketch Tools > Sketch Picture) allowed me to quickly get an idea of where the walls and holes should go. The ratio was different so I had to tweak the locations but in general the path is the same. Actually the size was determined by the piece of countertop I bought from the Habitat for Humanity Restore. Countertop was great as it’s sturdy and pre-finished.
To save some time, I used the Weldment features to create the walls. I only needed to create a 3D sketch for the wall locations and created custom Weldment profiles. The outside walls are made with 2×3 lumber. The inside walls are 1×2. I could get my complete cutlist automatically. A simple hole table gave me the locations of all the holes.
So you may be asking, how is this giant board going to pivot? Rather than using the original method of knobs with rods and string, I thought I’d keep it simple. It just needs to pivot on a point so why not attach a spherical door knob on the bottom. Problem solved. And it was cheap at the Habitat Restore!
So here is the completed project. I added 8 handles (2 per side) so you can actually have 4 people playing at the same time. It gets interesting when all 4 are fighting to control the board.
But then I started thinking that since I have it modeled up in SolidWorks, why not solve it virtually. Using SolidWorks Motion, just add gravity and 2 motors on the sides and a few hours figuring out the required angular displacements in each direction (by trial and error) and voila. Thanks to Wayne for his knowledge on video rendering with PhotoView, you can choose to view this video in HD 720p.
2 Comments (+add yours?)
Leave a Reply