Contrôle des messages d'avertissement et d'erreur de SOLIDWORKS
Article by Alin Vargatu, CSWE updated April 16, 2012
Article
On top of adding a lot of new functionality and enhancing the user experience for the latest release of SOLIDWORKS, the developers dedicated some time to address some little quirks in the interface that did not make too much sense and were a source of confusion.
A good example for that is the section in the System Options dedicated to control the warnings and error messages. In SOLIDWORKS 2011, there were various places in the System Options were these settings could be found.
Some were found in the “General” section (fig. 1).
Fig. 1. SolidWorks 2011 – General Options
The controls for the dismissed messages were grouped in a section called “Advanced”, a title that was really misleading (fig. 2).
Fig. 2: SolidWorks 2011 – Advanced Option
Fig. 3: SolidWorks 2012
Liens connexes
Obtenez des services SOLIDWORKS certifiés de Javelin
Javelin Experts peut vous aider à :
Posts related to 'Controlling SOLIDWORKS Warning and Error Messages'
