SOLIDWORKS Knurling

How to Show Part Knurling in SOLIDWORKS – Part 3

SOLIDWORKS Knurling appearance can be added on a per face basis as shown in part 2 of my SOLIDWORKS Knurling series. The knurling appearance was applied along the entire cylindrical face until the radii starts a new face. What if you don’t want the appearance…

Read More...

How to Show Part Knurling in SOLIDWORKS – Part 2

In my previous SOLIDWORKS Knurling article, I promised this process would get much easier than being thrown into the deep end like in part 1. This is a kiddie pool in comparison. What I’m going to do in part 2 is very similar to what…

Read More...

How to Show Part Knurling in SOLIDWORKS – Part 1

SOLIDWORKS Knurling Part

We all know what knurling is, right? The most common use for knurling is to add grip to an otherwise slippery part. Using this is done on a lathe, turned with special bits or tooling. Now, how do we get knurling on a SOLIDWORKS part?…

Read More...