SolidWorks Electrical : Cross Reference settings on a Title Block

Setting up a Title Blocks requires that every detail of information is laid out properly.

There are 2 ways that the cross references can be automatically placed on a Drawing sheet. However this depends on the Title Block settings.

In the Title Block Manager, Select  a Title block and then go to the Properties

1) The First Cross reference Offset is Set at 15, this means that the Cross references would be placed at distance from the parent symbol within the Title Block

The results of the first setting is shown below and the cross reference shows up on the left away from the symbol

2) The Second Cross reference Offset is Set at 0, this means that the Cross references would be placed right next to the parent symbol within the Title Block.

The results of the second setting is shown below and the cross reference shows up on the left adjacent from the symbol